Arvex Cranes manufactures electric wire rope hoists for steel plants, fabrication units, production lines and heavy workshops. With a grooved rope drum, high-strength wire rope and pendant control, this hoist gives smooth, fast and dependable lifting for demanding duty cycles, and fits on EOT cranes, monorail beams and gantry cranes. Load tested before dispatch and supported across India.
A precision grooved drum and rope guide keep the wire rope winding neatly in layers, which avoids crushing, twisting and uneven wear. The rope is anchored securely on the drum, so the load stays under control throughout the lift.
An electromagnetic brake holds the load the moment the hoist stops or power is cut, and a secondary or mechanical load brake can be added for heavy-duty lifting. An overload limiter stops lifting beyond the rated load, which protects the rope, the motor and the structure.
Upper and lower limit switches stop the hook before it reaches its end positions, so the rope is never over-wound. A safety latch keeps the sling secure on the hook, and an emergency stop on the pendant cuts power instantly during any hazard.
Wire rope hoists lift coils, billets, plates, rolls and heavy sections along the production line, giving fast, steady lifting for long working hours with minimal downtime.
Used on EOT cranes and monorails to handle dies, moulds, press parts, large fabricated frames and machine assemblies, where precise load positioning and higher lifting speed matter.
Helps with turbine, pump, motor and gearbox lifting during plant maintenance, and supports repeated material handling in process areas where the hoist works under demanding duty.
Our team checks the crane girder, monorail or beam where the hoist will run, including its strength, rail or flange condition, end stoppers and power supply point. The hoist and trolley type are confirmed against your load, lifting height and duty before fitting.
The hoist is mounted on its trolley or fixed foot, and the wire rope is reeved correctly through the hook block and anchored on the drum, so it winds neatly in the grooves. The power supply, pendant, limit switches and emergency stop are then connected, and the phase direction and limit switch operation are checked.
The hoist is first run without load to check smooth hoisting, lowering and trolley travel. It is then tested with a rated test load, and the brake, limit switches and overload protection are verified. Your operators are briefed on safe use, correct sling attachment and daily wire rope checks before handover.
A: An electric wire rope hoist is a lifting machine that raises and lowers loads using an electric motor, a grooved drum and a high-strength steel wire rope, controlled by a pendant or remote. It is used in steel plants, heavy workshops, production lines and power plants, and is fitted on EOT cranes, monorails and gantry cranes.
A: Choose a wire rope hoist for heavier loads, higher lifting speeds, longer lifting heights and continuous or frequent duty. A chain pulley block is better for compact, light to medium lifting at lower cost. Our engineers can recommend the right hoist after checking your load and duty cycle.
A: A wire rope hoist can be supplied with a fixed foot, a monorail trolley or a low headroom trolley, and it can also be mounted on the trolley of a double girder crane. The right choice depends on your beam or girder, available headroom and how far the load must travel.
A: Check the wire rope daily for broken wires, kinks, flattening, corrosion and uneven wear on the drum. Keep it properly lubricated, and replace it when it shows damage beyond safe limits. Arrange a periodic inspection by a qualified technician, and always replace the rope with the correct specification.
We use cookies to improve your browsing experience, remember your preferences, and understand how visitors use our website. You can choose which cookies to allow. Read our Privacy Policy for more information.