Arvex Cranes manufactures electric chain pulley blocks for workshops, warehouses, assembly lines and maintenance work. This compact hoist lifts loads smoothly with a hardened load chain and pendant push button control, and it fits on jib cranes, monorail beams and EOT cranes. Load tested before dispatch and supported across India.
The brake holds the load firmly the moment the hoist stops or power is cut, so the load does not slip. An overload clutch or limiter prevents lifting beyond the rated load, which protects the motor, the chain and the people working below.
Limit switches stop the hook automatically at its highest and lowest positions, so the chain is never over-wound or pulled out of its container. A safety latch on the hook keeps the sling or load attachment from slipping off during lifting.
The pendant works on a safe low voltage control circuit, which keeps the operator protected from electric shock. The operator stands clear of the load, and an emergency stop button cuts power instantly during any hazard.
Electric chain hoists lift and position motors, gearboxes, dies, moulds, fixtures and sub-assemblies at production stations, reducing manual effort and the risk of back injury and part damage.
Used on a monorail or beam to raise and move cartons, drums, bags and pallet loads between the floor, racks and trucks, so loading and unloading stays quick and safe.
Helps remove and refit pumps, motors, valves, engines and machine parts during plant maintenance, garage and service work, where a portable or fixed hoist is needed again and again.
Our team checks the beam, monorail or crane girder where the hoist will hang, including its strength, flange width, end stoppers and power supply point. We confirm that the hoist and trolley type match your load and lifting height before fitting.
The hoist is fitted on the beam with a fixed hook or a push, geared or motorized trolley, and the load chain is placed neatly in its chain container. The power supply, pendant, limit switches and emergency stop are then connected, and the phase direction and chain movement are checked.
The hoist is first run without load to check smooth lifting, lowering and trolley travel. It is then tested with a rated test load, and brake, limit switches and overload protection are verified. Your operators are briefed on safe use, correct sling attachment and daily checks before handover.
A: An electric chain pulley block (electric chain hoist) is a compact lifting device that raises and lowers loads using an electric motor and a hardened load chain, controlled by a pendant. It is used in workshops, warehouses, assembly lines and maintenance areas, and can be fitted on a beam, monorail, jib crane or EOT crane.
A: A chain pulley block is compact, economical and easy to maintain, so it suits light to medium lifting at lower speeds. A wire rope hoist is built for heavier loads, higher lifting speeds and longer duty hours, so it suits continuous work in plants. Our engineers can suggest the right one after checking your load and duty.
A: Both options are possible. A fixed hook (suspension) type stays at one point, while a push, geared or motorized trolley type moves along a beam or monorail. Choose the type based on whether you lift at one spot or move loads along a path.
A: The hoist needs a strong, properly fixed beam, monorail or crane girder that suits the load and the hoist trolley, with end stoppers at both ends. Arvex Cranes checks the support structure and power supply point before fitting, and guides you if any change is needed.
We use cookies to improve your browsing experience, remember your preferences, and understand how visitors use our website. You can choose which cookies to allow. Read our Privacy Policy for more information.